Sentences with MILLIOHM
Check out our example sentences below to help you understand the context.Sentences
1
"The resistor has a resistance of 5 milliohms."
2
"I measured the impedance to be 8 milliohms."
3
"The circuit requires a resistor of 10 milliohms."
4
"The conductive material has a resistance of 2 milliohms per meter."
5
"The multimeter showed a reading of 15 milliohms."
6
"To improve efficiency, the resistance should be reduced to 3 milliohms."
7
"The high-performance amplifier has an output impedance of 6 milliohms."
8
"The wire's resistance was found to be 12 milliohms."
9
"The power supply has a maximum output impedance of 1 milliohm."
10
"The PCB traces should have a resistance below 20 milliohms."
11
"By decreasing the wire gauge, the resistance can be reduced to 7 milliohms."
12
"The motor windings have a resistance of 50 milliohms."
13
"A low-ohm shunt resistor can measure currents in the milliohm range."
14
"To protect the circuit, a current sensor with high accuracy below 5 milliohms is needed."
15
"The total resistance of the parallel resistors is 30 milliohms."
16
"The microcontroller's internal pull-up resistor is typically around 100 milliohms."
17
"High-frequency signal traces should be designed with low resistance, ideally below 3 milliohms."
18
"The thermal resistance of the heatsink is 25 milliohms per watt."
19
"The resistance of the faulty capacitor increased to 18 milliohms."
20
"The power dissipation can be calculated by squaring the current and multiplying it by the resistance, in this case, 6 milliohms."
1
"The resistance of the wire is measured in milliohms."
2
"A typical headphone cable has an impedance of a few milliohms."
3
"The power loss in the circuit can be minimized by reducing the milliohm value."
4
"The multimeter displayed a reading of 2.5 milliohms for the conductor resistance."
5
"The high milliohm reading indicated a fault in the circuit."
6
"To measure such low resistances, a specialized milliohm meter is required."
7
"The milliohm value of a component determines its effectiveness in current flow."
8
"The technician used a four-terminal sensing technique to accurately measure the milliohm value."
9
"The conductivity of the material was found to be 150 milliohms per square."
10
"Using thicker wires can reduce the milliohm value and improve overall performance."
